|Flow Rate||1-10 L/min|
|Max Outlet Pressure||2-3 kg|
|Max Inlet Pressure||3.5kg|
|Working Pressure||2-3 kg|
|Country of Origin||Made in India|
|Output Pressure||2-3 kg|
Medical regulator is used for oxygen breathing in hospital.
1. Mainly component name (Please see overleaf)
2. Mainly function:
Oxygen flow range: 1-10L/min 1-15L/min
2 Pressure reducing range: 2.0-3.0kg
3 Relief valve Pressure range: (3.5kg0.5kg)
3. Appliance introduction:
* Before using, please fill pour clear water into moisture bottle about one third
reaching water line site.
2 DF-2 blind nut straw into bolt head, make the pipe of flow meter square
3 Put off regulator(9), put on oxygen tube switch, so you will see the data
from needle position of pressure gauge(2). At last, straw flow on/off at
anti-clockwise according to patients need, adjust switch.
If patient need oxygen for a long time can nse nose pipe to help patient
6 Moisture bottle (20) circles at clockwise, adjust(17) oxygen hole to other site.
4. Attention point
Before using the suction, you will check all parts bad or good and clean it
by drying cloth.
Pressure gauge(2), regulator(3) no oil, otherwise explode.
3 Clearwater in moisture bottle keeps clean.
4 There is adjustable nut(6) in the front of plunder shall be straw at clockwise.
6 Relief value(7) (15) keeps out of danger.
6 Oxygen dosage is decided by doctor.
After using suction, put off the oxygen tube switch, make rest oxygen out,
pressure gage to zero site, last put off flow switch if using again, first put
on the oxygen tube switch, avoid exploding.
5. If you don't understand, plese contact to us.